Industrial Metrology Centre–Technological Support Division–Dimensional Area and Mechanics

 | shareprint

Industrial Metrology Centre–Technological Support Division–Dimensional Area and Mechanics

Juan Pablo Contreras Samper

tel. (+34) 956 015 257

fax. (+34) 956 015 257


  • Implementation of measuring, calibration and certification activities, in the magnitudes of length, angle, geometric parameters (roundness, flatness) and threaded objects.
  • Implementation of dimensional and geometric measurements (roundness, flatness, perpendicularity, position straightness, parallelism, cylindrical, concentricity, coaxiality, radius fluctuation) and surface finishes (R, W, D, P profiles in 2D and 3D).
  • Traceable calibration and certification in Mechanical Metrology: Mass (scales); Force and Torque (momentum); Pressure and Vacuum.
  • Advice on the design, introduction and auditing of Management Systems in Test and Calibration laboratories, in accordance with UNE-EN ISO/IEC 17025 ( with ENAC accreditation requirements) and UNE-EN ISO 9001.
  • Analysis, design, introduction and maintenance of integrated metrology and calibration management systems, in accordance with regulation UNE-EN ISO 10012:2003 and UNE-66180:2008.
  • Design, development and introduction of computing applications for laboratory administration.

ENAC accreditation (180/LC486) for calibrations in the Dimensional Area, in accordance with UNE-EN ISO/IEC 1702:2005.

For further information on capabilities and queries visit and ENAC web site ( for further details on accredited calibrations.

Calibration procedures in accordance with UNE-EN ISO/IEC 17025:2005 standard. Calculation of the uncertainty of measurement, in accordance with EA-4/02


culture (16)  education (17)  energy (14)  health (14)  history (22)  language (12)  law (14)  literature (15)  sea (18)  social (11) 

Research Groups

AGR (3)  BIO (1)  CTS (34)  FQM (24)  HUM (49)  RNM (17)  SEJ (32)  TEP (22)  TIC (9) 

endorsed technical services

AGR (2)  BIO (1)  CTS (4)  FQM (5)  HUM (2)  RNM (12)  SEJ (1)  TEP (15)  TIC (5) 


It sends your email, and we will inform to you into our new features

Technology Transfer Office (OTRI) | Vice-rectorate for Research and Transfer | University and Enterprise General Management

CTC | Benito Pérez Galdós, s/n - 11002, Cádiz | phone (+34) 956 01 57 45 | fax (+34) 956 01 57 46 | e-mail | |

© University of Cadiz


content sharing

To share this information, including in the form your name and email destination.